Skip to content
Dr Artex -BL17 – Baffle Plus (05mm, 14sh)

Dr Artex -BL17 – Baffle Plus (05mm, 14sh)

R 1,599.00 - R 1,599.00
R 1,599.00
R 1,599.00 - R 1,599.00
R 1,599.00
SKU DRA-BL17

PROPERTIES
A combination of :
– extremely high level of noise and heat insulation
– high-temperature stability, material does not drop from doors and roof
– waterproof, material applicable for floor and external door frame
– high elasticity, material easy to apply on curved surfaces

Car chassis is like our skeleton. Its wellbeing is essential to overall vehicle safe function. Due to its nature, the chassis transfers a lot of noise and vibration. DrARTEX Advanced product is designed to be flexible and to adhere to any surface. It has the highest vibration dampening properties. In addition, it contains anti-rust additives to ensure that the chassis does not rust.

A newly developed material designed to serve the dual purpose of sound and heat insulation, while heavier than Baffle – it has a significantly higher level of sound insulation. High structural stability provides for a melting point at 140°C and no moisture absorption. The high elasticity of this product makes it very easy to install in even the most complex areas of the car.


COMPOSITION
Chemically cross-linked polyethylene foam with added 0.4 mm synthetic butyl rubber adhesive layer and anti-adhesive paper.

APPLICATION
This material should be installed on clean, dry surfaces, including on complex surfaces. (WARNING: Not to be installed on corroded metal surfaces!)

First, clean the surface from dirt, it is recommended to use water with neutral detergents, which do not contain organic solvents and alkali. After surface dries, degrease it with white spirit, gasoline, or other solvents and allow dry completely.
Peel off the anti-adhesive paper and thoroughly press against the surface, avoiding the formation of air bubbles between the surface and the material. Roll the material with a roller, pressing it through so that there is no air trapped between the material and the surface (use the “from the center to the edge” technique ). It is best to apply the material in working environments with temperatures between 18 and 35°С.

● Recommended application areas: Doors, Roof, Floor, Wheel Arches.